MACWAX ( Wax Based ) Spray Mould Release Spray 400ml, Release Agent, Polymed, Titanic FX, Titanic FX Store, Prosthetic, Makeup, MUA, SFX, FX Makeup, Belfast, UK, Europe, Northern Ireland, NI

    MACWAX ( Wax Based ) Spray Mould Release Spray 400ml

    €23,95
    Tax included. Shipping calculated at checkout.

    PLEASE NOTE: Aerosols can currently only be shipped to the UK and Ireland.

    If you are outside of these locations, your order will be cancelled and refunded.

     

    MACWAX is a blend of waxes dispersed in rapid drying solvents and packed in aerosol form. This product does not contain CFCs, 111-trichloroethane or any other kind of halogenated solvent.

    Special Properties

    Low mould build up
    Easy Release
    Good sealing of porous surfaces


    APPLICATIONS

    MACWAX is suitable for use with many casting materials and a variety of mould types. Typical casting materials are polyurethane epoxy acrylic and polyester. MACWAX is also used extensively for moulding flexible semi-rigid and rigid polyurethane foams.

    MACWAX has been formulated for high quality general purpose moulding at temperatures from ambient to 80°C.

    MACWAX may be used where a silicone release agent is undesirable such as when the moulded part needs to be painted or bonded.

    MACWAX may also be used as a sealant for wood stone cement and other porous surfaces prior to moulding. Very porous substrates may require the application of a specialised sealant prior to application of MACWAX

    The material is in a ready to use aerosol. It should be shaken well before use.

    Usage Details :

    The material is in a ready to use aerosol. It should be shaken well before use.

    The aerosol can should be held 250 mm - 350mm away from the mould surface. The can should be kept moving during the spraying otherwise patches of excess material will form. If possible the spray should be kept perpendicular to the area being sprayed.

    The application of a number of light coats is preferable to one heavy coat. Light coats allow the solvent to dry more rapidly and improves the surface finish.

    The application technique used will depend upon mould geometry. Deep Sections undercuts and recesses often cause incomplete coverage by parts of the mould surface from the release agent spray. This may lead to difficulty in releasing the moulded parts.

    A thin sprayed coat should dry within 2 minutes at 20C. Higher mould temperatures and a current of air over the mould will lead to shorter drying times. Casting onto release agent which has not fully dried may cause softening of the surface of the moulded part.

    BACK TO TOP